Engine speed sender G28

Post Reply
User avatar
Deylan
Finally has his VR6.
Posts: 190
Joined: Sun Jun 21, 2009 11:49 am

Engine speed sender G28

Post by Deylan »

The engine speed sender monitors the engine speed and reports the value to the DIGISWING control unit. It is required so the DIGISWING controller can start the engine correctly (i.e., disengage the starter motor once the engine has fired), as well as being used to master the clutch (i.e., to determine when to open or close the clutch). It can be used to substitute data if other sensors fail (for example failure of load signal potentiometer).
"I've been guilty of hanging around...."
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests